Full Power graffiti remover for porous surfaces which removes spray paint on the first pass, removing the need for harsh anti-ghosting products.
Full Power breaks the graffiti up without dissolving it. This prevents the graffiti from soaking into the wall. The broken up flakes of paint are then easily removed with a pressure washer without leaving any ghosting. State of the art formulation removes leather dyes, inks, stains and waxes, the new graffiti markers of choice. Full Power is not suitable for use on solvent sensitive surfaces such as plastics & polycarbonates. Though Selden cannot comment on the environment impact of the graffiti, this Full Power Graffiti Remover has an exceptionally good environmental profile. Does not contain either acids or caustics.
Application: Compatibility: Bare metal ✓ Brick, concrete, breezeblock & stone ✓ Bare wood (untreated) ✓ Polyethylene ✓ Polypropylene ✓ Any other plastic ✕ (will damage) Polycarbonate ✕ (will damage) Treated wood e.g. outdoor fencing ✕ (may attack treatment) Paint (any type) ✕ (will remove) Varnish (any type) ✕ (will remove) Fabrics e.g. cloth, carpet ✕ (will damage)
Directions: This can has a special high power wide angle delivery system. Hold can up to 18 inches away from the graffiti at arms length. Make a single vertical pass top to bottom, this should take about 1.5 seconds. Proceed across the graffiti until there is an even coating. Building up a “thick” layer will not speed up the removal process but will only lead to the product folding back over itself and falling to the floor. The product will adhere to the graffiti, and break up the film so it will wash off the surfaceThere is no traditional solvent action, the gel will not dry out. Contact time of up to 1 hour can be expected though less aged graffiti will remove much quicker. Scrub briefly with a stiff brush prior to removing with a pressure washer. On non-porous surfaces, such as metal, the graffiti can be scraped or wiped off with a paper towel. After rinsing apply Power Off sacrificial coating for long term anti-graffiti protection.
Technical
Composition A blend of oxygenated solvents, surfactants and rheology modifiers
Appearance Hazy gel
Colour Colourless
Density 0.9
Fragrance Low solvent
Stability Two years minimum
Biodegradability: All surfactants contained in Selden Products meet the requirements of the EU Detergent Directive 2005 – 2004/648/EC. This requires all surfactants to break down both quickly and completely into harmless material such as CO2 and water.
Storage: Pressurised container. Store out of direct sunlight. Temperature must not exceed 50oC
Aerosol Information
Propellant Hydrocarbon
Pressure 40 psi
Spray Rate 25.0
Product is for professional use only.